Separate names with a comma.
Just Add Nitro, about 30%, then back the timing down a bit and you will get flames. Not 10' tall but nice flames. Small adjustment in fuel /air...
Shouldn't this be in the section on tech questions
F I E (Fuel Injection Ent. LLC) owned and operated by Spud Miller. I believe he owns "Mallory super Magneto" now.
If you do some research on the inter net you will find enough info that should convince you not to mess with it. There are much better and safer...
I have read everyone of his books , starting with the first one he wrote. Each one has gotten better than the previous . They are excellent...
You don't need to worry about running a harmonic dampner / crank balancer . The blower being driven direct off the crank is a good dampner . Make...
Use about 10% underdrive on the 8-71 and assuming around 468 cu in BBC this will put you around 9 psi in manifold. As long as you don't buzz it up...
Many people have been getting good results using Bob Szabo's (Air density online) for initial setup and race to race tuning . Bob makes himself...
Thats kinda what I assumed(alky for fuel) . What has me scratching my head is the front four pistons being black. normally if I remember right...
Gas or Alky?
With the small tire, and stock type rear suspension, and 3400lb. weight, you are limited on what you can hit the track with at the launch. I...
With fresh set of plugs what do they look like?
How quick did you go with the procharger setup in that car?
What kind of car, how heavy, and what class do you plan on running ?
Not sure what class you are aiming for or type of car, but that combo with a 14-71 at around 20% over is almost Ideal for a 30% nitro setup....
This engine combo in a monster truck will have run times longer than that of a drag set up. High amp mags make horsepower but over heat on...
Good catch on the timing, 28* is a good starting point for timing. Previously mentioned combo running 36* of timing was based on 10.3:1...
4.25" stroke, use the 6.7" rods. Easy on parts with chevy block. Don't scrimp on balance job. Keep compression at 10.5:1 (+/- .25), spin blower...
What is engine combo going in? Put it in the block and measure lift and dur@.050" , lobe separation angle? check for proper valve clearance....
Wes get hold of Bob Szabo at www.racecarbook.com get signed up to use his online calculating system. Also I second the choice in using Spud for...
