Separate names with a comma.
C02 Bottle filling It is usually 150 lbs required or otherwise they will drop down a gear, You do Have a regularlater on top of the bottle they...
Firing up of it. Brian, It has been very interesting following the rebuild of your dragster in your off season, Good luck with the running of it...
Crower 10 inch, three disc. Thanks for the reply John, I have a 2 disc clutch and a 3 disc clutch and the adjustable stands that came with the...
Can anyone advise me what length the adjuster stands should be for a 10 inch, 3 disc crower clutch. with the small stands. What is the usual...
PSI 206 screw blower measurements Hi, Length is 20 3/4 inches from rear to front cover where snout mounts. width is 15 1/2 inches at the...
What is the torque spec for bottom blower pulley and centre bolt to crank hub on a BAE hemi, also what do you usually torque the top pulley too....
What brand and type of oil do you guys recommend for putting in the front of a PSI Screw Supercharger, and How much of it.
I have made a belly pan for floor under the chassis on a Top Alcohol Funny Car. But what do you guys use on the top side of the chassis rails for...
We are a one engine Top Alcohol Funny Car Team, with a BAE engine. Would be interested to put together a list of the suggested Engine Spare...
was just looking at a set of simpson funny car boots, and they seam a bit big for the size compare to normal shoes, Do you wear like other shoes...
I recently saw a funny car with mounts to support the CS1 lenco 3 speed with supports down the side of the lenco and mounted to a crossmember, as...
Race radios I just brought some from Dan Brown, and they are on there way out at the moment, from placing the order with him they were sent...
Have 8 mm Gt Blower pulleys, on a BAE with PSI Screw blower, 1600 belt is just too short, and the centre to centre measurement between the crank...
Link To NHRA Rule book Hi can someone type me in what the link is to The NHRA on Line rule book like what "John 348" just did on the above listed...
On Board cameras on Junior dragsters Good on you for this petition,
blower studs We used to drip the thread of the studs in Kerosone because of two aluminium products so that they would not blind as we screw them...
I notice that on late model Funny Car Bodies, that they dont seen to be using Hinged Tail Light windows in the rear of the Funny car Bodies....
lenco Air Pods fitting There is a fitting for the air line from the lenco shift buttons in the centre of the pod and beside it towards the outer...
I have brought a lenco three speed gearbox and the air pods have been plumbed up with nylon quickrelease fittings into the centre of the top of...
Well the pulley wont work then as I through, My Other stuff arrives next week so I will compare and if its not the same. I give it back to you, I...
