Separate names with a comma.
The pneumatic spring rate is less with beadlocks because you dont have a liner tire with 40 pounds in it. To low air pressure will wald up the...
With a 2 step you still have to hold the hand brake and the clutch in at the same time, as complicated as that is! By the way,I was watching a...
We've always been afraid of Cowie. Sodomy is legal in Canada aah.
What he said. You forgot no 1000 lift cams. Do 2 steps take the driver out of the equation in pro stock?
Aircraft paint remover/ paint stripper. You can get it at walmart.
3 pages and no one have mentioned the new comp cams elite lifters http://www.cpgnation.com/forum/comp-cams-elite-race-solid-roller-2862.html they...
Lean runs good in lower gears, no power in high gear. Fuel line collapsing, #6 tank vent is probably big enough for injected alky, you only run #6...
You can use a 2 step but 15 will still get you 20 unless its http://... The 2 step has been legal for awhile but not as long as http://...
2 step is legal But bald eagle is still illegal. Whats up with that?
Put another fuel system on it and put it in a tracter puller? http://www.sassyengines.com/
MGP'S and GRP'S haven't used MGP's in blown alky yet but I like MGP'S better.
Was the mag all you changed or did you change anything else? My freinds funny car with older fuel heads and 30 pounds boost went 6.35 with a...
You can push a car with a lenco backwards without pushing the clutch in. A cs1 has 1" gear and a cs2 has 3/4" gears, both use the same sprags. The...
If the 60mm cam lobe is better or I really needed that much more lift and I have a 2.125 ford cam bearing can I just grind down the mains and...
You asked for thoughts so here you go, I don't have any experience with with this so just my thoughts. Unless your getting a thicker stronger cam...
On our hemi it seems like we always float the exhaust first (after three runs) I put them all @ 2.050 with a new set of manley triples I get 485...
These are the only two I know of http://www.goodvibesracing.com/magneto_offset_drives.htm I run the dunn, it's not a very stout piece. It needs a...
I wouldn't worry so much about that bar as I would want more side bars in the driver area.
I cant tell by the drawing if the valve covers have spark plugs in them or not but if its a hemi and the bar went corner to corner it would hit...
Maybe its because I'm in Alaska. My uncle payed 70.00 for a oil pan heater at schucks and I went to AK Bearing for a seal or something and they...
