Separate names with a comma.
A lot of guys run a light weight shoe or sneaker inside the fuuny car boot so the clutch pedal does`nt hurt the bottom of their foot. Simpson...
I have worked on several funny cars, and I have seen some really dangerous reverser handles; steel with a "T" welded on the top. The first thing I...
I don`t what kind of retaining rings they are, but you can try Mcmaster-Carr, they have just about every kind of retaining ring there is.
Ditto on the White Lithium Grease.
If I remember right, the 65ht is 2.5 inches wide, and the 75ht is 3 inches wide.
If you look at the way a hemi crank is drilled, you will see that the rod gets its oil when the oil hole in the crank feeding that rod is lined up...
Two things about the way Nathan has his plumbed: [1] Filtering the returned oil before it gets to the tank is a good thing. [2] If you put a lot...
Hi all, working on an altered with a 9" top loader. I know how to replace gears on a standard 9", but the previous owner says we need a "Tool...
There should be NO exposed thread. They should be flush with the chamber, any exposed threads could be a source of hot spot to cause detonation,...
Hi, I forgot to add, I am looking for the one with the aluminum center, not the plastic one. Thanks.
Hi all, does anyone know where I can get the air shifter line rotator assy that goes on the sterring column for a funny car 3 speed lenco. New or...
We had Veney heads, and our rocker stands were seperate from the head studs so our rocker stands were only torqued to 50 ft lbs.
Only my opinion here, stock rockers are fine for what you are doing.
I know your going to get a lot of opinions on this, but here goes, sounds like you may have stock exhaust rocker arms and shafts, thats why they...
what we have done and seen others do is drill a hole in the shaft [exhuast shafts only] facing up, between the rockers, just large enough to fit...
ours was always around .050, plus or minus .005. Also, where are you checking the clearance? always check between the rods, not on the side that...
Hi all, we are looking into building a blown alterd, hemi, lenco drive. My question is; we want it to be self starting, so what starter do we use,...
all we did was wrap an axle strap around the front weight bar.
Our motor would collapse the domes at 1175. 526 hemi, PSI D rotor, 47 psi boost
Are the piston skirts scuffed also? If they are, stage temps to high will cause this.
