Separate names with a comma.
take it from experience, as soon as you shake the tires with a psi and a mag manifold it will break. especially if you grind on it and make it...
don't know if this has anything to do with it, but is your rotor phased correctly? Also check to see if the rotor is tight. Check the nub on the...
my drive studs are 5/8, but they have an 11/16 non threaded shoulder that the wheel slips over. So, yes the wheels are for a 5/8 stud, but they...
This may sound stupid, but i have used this for years and it works. Put a couple drops of dish detergent, [Dawn works good] on the inside of the...
put the piston on tdc. remove spring, let valve rest on the piston. take a dremel with a stone on it, and spin the valve with your fingers while...
the tach and the convertor are not shutting down. The tach is seeing less pulses because the two step is shutting down cylinders. thats why your...
Everyone will tell you they were good heads in thier day. The car i work on has WAR 105 cc alcohol heads. You can`t find an intake manifold,...
brake tech Hi, first, 10 to 1 lever ratio is not enough for a hand brake. if you are now making 600-700 psi, thats about right fot that ratio....
Why are the wheelie bars 9.5 inches off the ground? With the bars that high, the car has so much momentum going up that when it hits the bars it...
You can change the timing and fuel all you want but the blower will still stuff the same amount of air into that cylinder, which is more than the...
on your last post you, answered your own question. yes the inner panel is sucking in when you close the blades. if the screw in the bridge is not...
Nitrobandit has it right. make it out of aluminum, drill holes in it to make it lighter. the holes not only make it lighter, but the lever will...
Ok, input and trans came from different people, the collar is down the shaft a little too far. Now i can put it where it belongs and check the...
yes, i am refering to the collar on the input that rides on the seal in the front of the trans. What i am asking is, how far down the shaft should...
Hi all, what i have is a cs1 course spline 3 speed trans. My question is: how far down the shaft should the sealing ring be? It appears like its...
I always go with 1/8 toe in. I just wasn't sure about the camber.
Thanks, Tom.
hi all, what would be a good camber setting for 125 inch blown hemi altered solid mount suspension front and rear. adj. a arms in front. Thanks Tom.
using your numbers, your tire grows to 37 inches, assuming nothing is slipping. So, using 37 with a 4.11 gear your rpm will be 8650. this is...
The 7-AL3 will lose 4 degrees of timing within the box from the AL2. It`s in the instructions. Also, the 3 needs good wires. MSD 8.5 mm wires...
