Separate names with a comma.
pin What is the pin clearance with new rod and pin? What pin diameter do u use? Did u re-use the pins.
timing Good point.... Power Grid/Race pack will i be able to record actual timing or just display the programed map?
Power Grid I am looking to have better recording of the timing map to race pack. Will we a be able to use a two step? We have 8147 box?
Thinking of switching from 8973 to power grid 7730, we use MSD 44. Any input would be appreciated. Thanks.
wiring I had a simular problem... changed the wire to the pick up... problem went away.
$$$$$$ Its all about $$$ Its cheeeeeeper for the NHRA.. they dont CARE
Gapless Rings I tryed all of them ... The BEST rings period is... http://bwepistonrings.com/ give him a call he will explain in more detail...
Comp 10-1 to 10.2-1 :o
Bearings I run Calico coated Pistons and bearings Screw Blower. 9000rpm, parts last longer.
hat opening The JBR has a opening of 4 1/2" x 12 1/2 vr the full tryangle opening of the PSI. Did anybody switch and see any gains in ET with the...
We run 1/8 mile, BBC PSI-D 124 over, With JBR front loading hat. 8900 – 9100 rpm. From your experience is there any gain going to a full open...
Starting line You should look at the G-meter when the car moves... I have a 12v signal sensor on the T/B to see when released... We have 8...
exhaut You have extream cylinder presssure pushing back on the ex valve, I would check cam timing or maybe worng cam for aplication. Do a comp...
Bring Your Promods !!!!! ShakeDown at E-Town Gates Open < clock <<<
Just to let you guys know the best Outlaw race on the east coast is around the corner at Englishtown Raceway park Oct 7-9 check it out...
Weld a small plate on a 45* to close off hat /match the blower opening... we did it fe times.
F3 We had a mechanical set up with F3...440 sbf it sucked... put a MFI system on it workes great... If i were you i would NOT go with mechanical...
Front bearing Had the same problem with BBC Aluminum block. we pined the front lower cap. Same as rods.... Problem solved.
Icing Icing, Not the Stuff You Like... Spray some de-ice on butterflies...
What is the max piston pin clearance you would run? We start with new billet rods/pins .0015-002, after few runs 004-005.
