Separate names with a comma.
I am in the process of planning my new chassis build. I have decided to go with a chassis kit. I'm looking at the Mark Williams kit and the S&W...
The reason I have discovered not to run pressures up that high is you tend to bend/twist pump shafts over time. As far a performance, I'm going to...
If your floater hub is broken off then it sounds like it was just butt welded on. That is not the right way to do that. Sounds like the rear...
Ring in the head and receiver in the block. my 540 chevy has never had sealing issues.
Sorry to hijack but I would like some clarification. I looked at the RCD website at the crank mount starters like the ones talked about in this...
I am in the process of building a 125" altered and my drawing has a crank centerline to ground of around 16" (depends on tire size.). This gives...
x2 on the bore sixe. You will have a real problem o-ringing between the cylinders. Or even the MLS gaskets are iffy with that little material....
A lot of the old school guys will tell you if you don't have the throttle control to do a burnout without a stop you shouldn't be driving a race...
Got me thinking also. They say .250 " on the build sheet but its actually .2075". The hole is .085" . So I guess its better to say they are .200...
I always remember what Terry Manton told me. Run the biggest rod you can, even if you have to grind to make it fit. I run 1/2" straight .250" wall...
Guess I should have just popped one apart before posting. Extremely simple cylinder. Thanks Corey
I have a Lenco 3 spd that I am putting air pods on. The trans came with these pods but for the last 10 yrs I have been using lighting rods, I want...
Same here, start in high gear. Some of the low hp cars I have seen start in first and then pull right into high gear, passing over 2nd.
Thanks Mike, Good advice. I may go get a small amount and see how methanol reacts to it. Corey
I've been doing some research into 60W oil in Edmonton. I can get it but its anywhere from $11 to $15 per Ltr. Now I understand racing is...
What he ^^^^^^^^^^^ said.
Lenco cross shaft here. 7/8" od and 48 spline. 4130 steel. I have a Lakewood bell ,it had an aluminum shaft like yours. I phoned Lenco and the...
The big thing I have found with any throw out bearing is if there is something that pulls it away from the clutch fingers when the clutch is...
Discribe "many problems" that may give some insight. Corey
As well, I ran stainless exhaust valves for a season. The valves were so brittle they shattered like glass. Switched to superalloy.