Separate names with a comma.
Splay cap is $8250 Cross Bolt is $9000 Cross bolt would need new pan and front cover/gears as raised cam by .250" Trouble is were standard...
That is definitely strong!
Alright all, After some advice/opinions please - CN blocks sell a very nice splay block (standard deck) and also a cross bolt version....
What I find amazing is the programming behind this! How long must that take?!
We run an altered. 511 cu in BBC, clutch, 3 speed, we use beadlocks with no issues Did run 36" tyre had bests to date of 6.42 @ 191mph...
bare ally here too...but we drain after every event, whole system.
Joe, easy enough job, did you try kenny @ superpower?
Memory wise its not going to come close to 4130, but just wondered if it was worth looking into. Having had a read about I think it might be...
I am after some information regarding the use of titanium for wheelie bars. Are they designed differently? What grade? Just curious...
We use 62-1520
Same here, K&N Great product!
We use B2's and change them every year
70 is very brave. We might do 20 tops in a season but change rods every season As for bearings, depending on how hard we run, either every...
We run RCD one (big block chevy) Just looked on site and bearing says... 50 X 90 X 20 BALL BRG DBL SEAL Not sure on setup though can you...
We used to run inline filter now use system one. make sure with inline you leak barrel valve down with this is as we found it made difference...
We have run as low as 11:1 and up at 13.5:1 Higher CR means narrower tuning window For me 12:1 - 12.5:1 is about right and what we run now...
Might be worth a read... http://www.insidetopalcohol.com/showthread.php?32878-Clutch-can-weights&highlight=
or http://www.gospitzer.com/2010components.htm
Sure Mckinney will do them http://www.mckinneycorp.com/
Hope not! There a good wheel!
