Separate names with a comma.
Just as the title says, looking to see if someone has a 3.70 Big Pinion 9 1/2" Pro Gear lying around before I order one. Please let me know if...
Only made four runs and three were not the best, LOL but the belt was flawless. I tightened it up as much as possible per the recommendation and...
Pretty interesting. I wonder what the Roots lobe type pumps do in comparison to the G Rotor and the gear pumps?
They use different pulleys with a different bolt and pin configurations. The PSI pulleys are more common but only go down to 32 while RCD will go...
I was told third party that Pedregon thought there was 150 HP benefit from a 11 MM to 8 MM belt. RCD may know as they supplied him with the...
A MSD 10 Plus box just popped up on eBay.
Really a bummer that MSD dropped this. I ran both the old and new. Took less power to run than the 8 and would fire just about everything. Only...
You may want to check with Electrimotion. At one time I believe they fixed those too. Not sure anymore.
Great, can you zero us in on our area that we are looking for? 3.5" 8MM GT Pulley with a 2" register and a 2.782 bolt center? What page can that...
It does, thank you much. Nice easy formula too!
I would except it is Sunday. I thought Robert would chime in too as he has them too.
Anyone know the outside diameter of a 73 Tooth 8MM GT Pulley? Appreciate he help.
I have one with the shaft that goes in the reverser to place the gear in the rear case. Comes with the clutch drum and an almost new ring gear...
Not too surprised. Most of those guys are fully opening their injectors while mine is opening just about a 1/4" with an air throttle.
No expert here but if you tighten the crap out of the belt it lasts a long time on a screw with 8MM GT. Using a 1600 84GT PS belt and it is waaay...
The Reds are fine just inspect them once in a while. The clutches next to the pressure plate wear the most so they are a good indicator how...
I use the blue plates in mine but that does not make any difference as the clearances are the same. If you run new disks, they are going to be...
1/2" NPT to -12. Even with this, you need to extend it out a bit. http://www.anplumbing.com/product/tab/8028?tab_id=3
While quite expensive, I use this one. It is accurate and fast once you set the first one up. Digital is the way to go when close enough is not...
That's pretty cool JR. Now we just need to add a lanyard so the cap doesn't disappear. My guys keep losing it, LOL. Tom
