Separate names with a comma.
4.6.2 is the current version and it works fine on any Windows 10 system. Don't buy another laptop.
I run both and have never had a problem like this with either. Don't have a super high discharge pressure though, normally not over 200 LBS.
Saw this the other day: http://www.racingjunk.com/Blocks/182680153/NEW-K-B-OLDS-BLOCK.html
Also looking for the case plug to block the servo hole.
Looking for the larger 1.28 and up fine spline rear main shaft for a CS1. I have a 1.25 fine spline shaft to trade if interested. Also looking...
If you go to Gorr's website, they go up to 170 @ 150LBS. Enderle only goes up to 209 main pill if I remember correctly.
This thread really got me thinking on the engine braking comments. I always thought people wanted to limit engine braking by putting the car in...
I watched that run at least a hundred times. Thank you very much MotorMedia for not taking it down. I'm sure Ronnie would like the racing...
If you were not breaking belts before or not as many, I would go back and look at the changes made. The 84MM belt would not cause you to break...
Longacre digital 0-25. Mine does both the rears and the fronts which are 40LBS. I'll never use an analog gage again....
What shifts the trans, Clipper buttons or ACD controller or? Always high gear burnout. The old recommended shift in the burnout was for low...
Are you talking a screw blown motor? If you are, there are actually three circuits. One is to lube the blower and idle the engine and is on all...
Looking for a good 23 Gal Waterman Lil' Bertha Pump, no junk. 3/8" drive. Please let me know what you have. Thanks. Tom (224) 374-2786
I'd consider the FIE setup as the components are encased in epoxy. When I used it, it worked great. That is until I broke a belt and the belt...
Voice of reason, see ya in a couple of weeks Dan.
I know there have been a gazillion discussions on the best rods but I have a question on them. I'm not trying to slam the manufactures but I'm...
[IMG] Coils are on lower left for even bank, same on other side.
I have a -12 that was mounted but never used. $450 shipped. Tom (224) 374-2786
What engine did you run that in and what kind of performance did you get out of that size cam?
Looking for a friend. Need a block from one of the three makers above. 10.2 deck solid, 54MM cam located at +.250, .904 lifters, 4.440 bore with...
