Separate names with a comma.
Give me a call wildcat,I have a manifold with a small crack in it you could use to possibly get you going Dale-970-302-1232
I think we need some good ole contraversy to pep this site up!(lol) so I'll start. I think when a driver is interviewed on T.V. its...
I think the fuel classes should run a fuel pump with a reduced gallonage to slow them down just a bit.You can only make so much power with so much...
George Zadel and I ran a T/AD in Div.5 from 1993 to 2003 with a Ford engine with custom hemi cylinder heads and block that I manufactured.I put it...
I have 4 nozzles on top (about 80 thou each) with the front 2 having, I believe 30 # checks-so that there isn't too much fuel at idle. You would...
Believe me, I learned the hard way that when there isn't fuel on top, the rotors heat up enough to start rubbing the case! The heat is from...
Kind of cool to think that Clint was the last person to race the Ace. Congrats from another tractor motor owner. -Dale
We had Murf Mckinney build us a chassis the end of last year with a shoulder hoop of 22". He said he built a chassis for John Force 23" wide, but...
We have the same thing on our car but we stayed with the 36 rears and put a 25 front on. I put a .10 lower gear to compensate for the bigger...
The first thing you have to know to tune a car is what the GPM the pump puts out.Then blower size,overdrive,engine size, and then elevation(air...
In my opinion it not worth it, plus you can find off the shelf cams with 55mm journals. I got one from Crane. R-292-5152-2S-17 SFO 55J Dale
Give me a call Dale 970-302-1232
Don't you have to make sure and use tubeless liners and not the old liners that have the slots in the bead? Dale
If you need help with this motor, I might be able to help. I live about 40 miles from you,and have a MBR in a funny car. Dale 970-302-1232
Hey Mike, What do you think about the effect of compression and load on a motor? If compression is higher or load is more, do you think it could...
The bellhousings we run have both patterns. The B&J is slightly bigger dia.pattern. The housing mgf. should be able to drill the pattern you need....
Be careful when using lashlocks.They need to to be installed with no clearance between the top of the valve stem and the bottom of the lashlock....
You can get a bulkhead fitting with a 1 1/4 nipple from the likes of Earls,Aeroquip, KB fittings etc., -Dale
You need to drill a small hole clear through the casting at each end of the crack, making sure that the crack don't go past the hole otherwise you...
You mention the BDS manifold specifically, any idea on others? Or is it a trial and error thing? I have an Indy manifold. Corey I think...
