Separate names with a comma.
I like R&R rods, and we have Arias pistons that seem to be doing good, they did cost more because it was a custom piston.
60% to the hat, or as much as possible. To get that we use pretty small port nozzles, way under .038 (if that # is a diameter) our port...
I would think the aluminium pulleys would have a little more flex to them, good or bad I really couldnt say.
We ran 20% a few times NA injected, with a vertex mag and it did fine, now we use the same mag on a blown alky motor. More power at the plug is...
I dont know much about BBC blocks, but I know there are people in here that run them plenty hard. About the torque converter question, nitro...
Just with that CR you probably want to stay below the 25% mark, you really dont need to change your fuel tuneup much if you stay below 25% either.
I did check all the lifter bores and they look fine, I havent had the pistons out to look at the skirts in a while though.
wedge motors There are a few of us wedge guys out there, I think the main reason people always lean toward the hemi is the simple fact that more...
Cold oil=bad. We plug it in whenever the car is in the pits. 70 wt Brad Penn, dry sump.
I looked over my motor pretty well just now, the counterweights are not hitting the small end, no (self clearancing) of parts. Im positive now...
Just a wild guess here, but I'd say you are way fat still. With that kind of 60' and MPH I would expect better 1/8ths than 5.1s Just curious,...
Its a 4.500 stroke on a 2.200 pin. I think I know what you are talking about, I'm pretty sure its not doing it but I sure will take a closer look.
The rod bearings are definently not rubbing in the raidius, we do see the mains roll off some babbit sometimes like you said, but not enough to...
This is a powerglide car. Don Onimus, Im sending a PM.
Here's the deal. This year we are seeing some very fine aluminium shavings in our oil filter every pass, not a huge amount but enough to make me...
If the tank swelled up on you, your tank is not vented right. There should be NO pressure in the tank.
I'm definently no blower expert, but I was under the impression that more degrees contact between rotor and case was the whole idea behind the...
Its normal to see belt dust, but I've never seen aluminum. That might make me nervous enough to start looking for the source. After about 5...
In Don's defence Was working at a shop a few years back running a job for the Army. Certified aircraft quality steel 8620 paper work...
This is the old man talking here. We run a dry sump system in our car. It's a old Weaver 5 stage pump 4 suction 1 pressure. All of the lines are...
