Separate names with a comma.
Looking for some Injected guys to give an opinion. Running nostalgia a fuel. 392 AJPE. We are running the short runner "hot heads" intake with...
Ran a blown 350 at 30 lbs, had copper gaskets, and O'rings, that were marginal....switched to a cometic gasket and it was awsome!! Sealed when...
No insult! It was early am.... The "idle circuit" I am talking about is the little pilot hole (used for the secondary idle, for the big...
Just switched from a alky square valve on my blown deal...to (used) k valve on the injected nitro motor. As soon as i load the barrel valve...
Untill you can get into a clutch deal....run a VERY low stall speed. 2500-3500 rpm! Anything higher is going to be so violent at the hit (any...
Sent you a PM regarding a titan clutch that is available.
You will run enough fuel through the motor, it will stay cool enough like the guys say. Be a little aware...the exhaust vavle stems/guides get...
Frank, Your gear may be to short. The car will leave hard, (it may rattle the tires), and rev the motor way fast. The motor wil be at 8500...
We actually did fine. I could see the heat (tempering) on the wire...and then down into the threads. It always matched the racepack. Two threads...
I have had great success with autolite stuff. Never burned up, and never dropped a cylinder. I have switched to Nitro so I have some alcohol plugs...
Are the starters, radial piston engine starters? If so from what era or engine. Or are they turbine starter/generators?
Thanks. Dealt with that on my ssi, blown small block. and a msd 12. Samething, fresh springs, or cold oil...the slightest change. Went to 16v on...
Thanks, I am trying to avoid, all the jumper wires, and multiple, big heavy batteries. I have trick little super expensive aircraft batteries,...
Has any one run only 24 volts to their rcd type (aircraft) starter with success? Have an injected 392, single 44, and a little 11 gallon pump....
I notice there are a lot of fuel dragsters going to, what looks like, a wider front tire. What is the deal with that? Why the change? I can...
Ran a 33X14" -15" rim, tall growth on a 14" wide American Bead lock. Behind our small block in A fuel, behind a powerglide with a 3500- 4000...
It is commonly refered to as "blade tape" It is designed for protecting the spare (closest part to teh hub) on the leading edge of a composite...
Thanks guys, I have a 17.1 that is out of date. We haven't run the car for 2 years. In the process of recerting everything....Funny, just like...
Knock on wood, I have never had a fire...so I dont have any clue how long the a 10 lb. bottle takes to exhaust. Can some body tell me the...
I had a tempermental 12lt. Chased it for multiple weekends. It turned out that the "new" slightly bigger, valve springs slowed the cranking rpm...
