Separate names with a comma.
I had a similar issue and it turned out it was my bellhousing centering on the crank that was the biggest issue. I made two offset dowel pins for...
I could use some stands if you are willing to sell. Have loads of ex and in rockers
I have not seen the fuel flow (flow meter) mentioned anywhere.... The way I set my stuff is 1) Set blade opening to 0.010 in 2) Start with the...
I run a -12 line from the tank to the pump and no problems. If I could go to a -16 line and would do it just to make sure the oil velocity is as...
I just got some from RBS, they had them in stock http://www.rbssuperchargers.com/Products/Lenco_CS_1_CS-3_Green_Tan_Clutch_Disc--2630%2D0018A
When the revs go up the torque curve usually gets more narrow and pointed . So the higher you rev and a more narrow and pointed it makes an...
I have a kevlar diaper from Stroud and it works pretty good no complaints.
You can also do it like this: 1) mount the bellhousing and torque it to spec 2) mount the dail on the flex plate and dail the the hole in the bell...
What I have done earlier is to measure the amp draw with a large car style battery and add everything up when it draws the maximum amps. All...
The lenght of the bruno bell housing face to transmission face is 5.550 in My bell is 6.375 deep which totals just under 12 in. If you are...
Lets say the we have a manually shifted lenco with the push button valves why not put a normally open solenoid (closed when powered) T'ed off the...
I have a bruno drive and I have noticed that the rod bolts loosen up a bit and I do leave the car in gear and let off the throttle at the finish...
We have been pulling from the blower for 3 years now and no problems. I also use it to winch the car in and out of the trailer with ramps. I...
PM sent
If they are still avail. Send me some photos.... mogens@ms-fab.com
Give BAE a call, they helped get a set together for my KB block
I think they are, I called them about 5 month ago and Tom told me that they only do parts now and not 3rd member builds.
The Push rods I run in the KB3/fathead 3 combo are: Intake manton 5 series 7/16 to 3/8 x 168 11.845 in length (manton item number 516-168)...
I run BAE Fathead on a KB 3 block with stock lifter spacing. It did require some grinding in the valley to make room for the push rods but it is...
Can I join in ? mogens@ms-fab.com
