Separate names with a comma.
My sleeve thickness is .150 and need to bore them to 4.250, so I am left with .083 thick? Not sure if that’s good enough to run a injection motor?
Willie I told u to send s message to stig sigarson. Look him up on the European classifieds, he has billet blocks fr sale. Don’t waste ur time...
and that’s on their blown short deck alcohol engine?
it will only be fr injection only, and small stroke. Non boosted.
. Thx dave
oh fr sure, but I got a lot of 4.187 sleeves. And can get 4.250 bore high compression pistons fr my needs. If I can get away with that over bore? Thx
have older KB dry and newer KB wet But have two older 2000 Brad billet too. But will measure the registers after work thx rob
PS not sure what block the 4.90 sleeves came frm?
on the sleeves I took that measurement. Can that sleeve be bored? If yes what’s the max? I need min 4:250! PS the newer top fuel blocks do they...
I have 4.490 OD sleeve. In a 4.187 bore, what can it be bored out to? If at all thx rob
. Ohh ok have t check rob, but what about the compression question? Thx
hi first what is the largest u can over bore a 4.187 sleeve? Next is what is the most compression you can make with a piston that is in a bore...
Hey Cyril if ur going to push it. Sell ur block and pay the difference. Get ahold of stig that runs too fuel he ain’t to far frm ya. Not sure...
Show pic
Bump thx
bump brother
what the min thickness u can run on a 1500 hp blown hemi? And what’s the pit falls of it? Thx
. How many times does ur v cover come off?? Every pass? Thx
did ur rockers have piling holes? Thx
Cool infr
