Separate names with a comma.
Being from Australia, are you sure you have the time differential right? If I remember right with some deals I had with Australians, they had to...
I had a mag Gerardot injector, fine sanded it and used black engine enamel with the ceramic in it. It has held up very well. I also had a lo...
I am looking to use the Brodix SR20 for our twin turbo BBC puller. What is anyone's experience/ advice with the SR20? They good, bad, doesn't...
I think somewhere in Spud's directions he says that the buzz box method is better than a light because with the light there is some "delay" and...
I don't know the answer, so I am asking as you guys are very knowledgable: Given the same engine specifications (block, heads, cam, fuel, etc),...
Ditto on the Pioneer. JW
For what it is worth, I run BB2X on 496 and 540 BBC with 14-71 at 45% over in tractor pull competition and they worked very good. We had some...
We did the 4-7 on both of the blower motors and carried it over on the turbo motor too. Didn't have any adverse reactions. JW...
For what it is worth--I have three in service right now. One in a naturally aspirated alcohol 540 BBC (tractor pulling), one in a 496 BBC, 14-71...
Isn't boost a resistance to air flow? If so, a poor set of flowing heads will show a higher boost given the same blower and OD than a set of good...
Profiler hands down. I think it is called the Sniper or Sniper Jr. It is what we are using for the twin turbo setup. JW
Have talked to Ken a couple of times in the last few days. We just had my block bored and the sleeves stayed in. We didn't go to 4.5 but my...
I can only tell you my experience with OC BBC crankshafts. I have a Callies that I have had for a long time and it still works. I also have...
Rich, If your customer is into pulling, there is a couple of guys in Australia that do containers. I have sent lots of tires over. I will have...
I have a $45,000 cashier's check drawn on a company in Florida, sent Next Day Air via UPS and I was to cash and send the balance to an address in...
I have machined the pumps and extensions to the contour of the pulleys for extra clearance. The QR system is the way to go for sure for easier...
Both of our 540's have a 6.70 rod (4.25 stroke--10.2 deck) around 10.5 compression ratio.. Have used Arias, Ross, and Venolia pistons with no...
We are talking blowers here, do the numbers and math apply to turbo motors or should those ball park numbers change?? JW
The KB Olds block is new to me. The sleeves protrude from the block. When checking for straight, do I measure the tops of the sleeves or the...
I agree. We used to run 40 degrees on a 496 with 8-71 at 45% using a Vertex mag and did very well. When we switched to Mallory 4's had to back...
