Separate names with a comma.
Oh, and yes--lots of clearance! JW
I ran Merlin and Bowtie iron blocks (540 with 14's at about 30 pounds) and never had an issue with main or rod bearings. I've ran with...
I have a cast Arias and the main and side bolt torque specs are that (they are stamped on the pan rail). My KB/Olds are slightly less than those...
Blue LocTite here also and then torque. Only time I have had failure is when the LocTite was forgotten! JW
When we were running 540 BBC with 14-71, number 2 cylinder was always a bit%$ keeping enough fuel in it to keep it from torching pistons, head or...
When we put the turbo motor together with the SR-20 heads, space limitations didn't allow the use of washers. After talking to Brodix, ARP, and...
Advanced Chassis in Antwerp, OH does a lot of different fabbed housings. 419-258-2100 JW
When I switched from blower to twin turbo (BBC), I used the blower cam with good results for a couple seasons tweaking our setup (my fuel system...
If the block is a Century and has dowel pins, Century would know where to get them. JW
Just make certain when you get two or three of them wired that you don't make accidental contact with the wrong terminal. The explosions can be...
This might seem like a dumb question but I know guys on here have the answers.....what is the availability of screw blowers, either new or used?...
Looking for some advice. Have talked to a couple of piston ring sales techs. Twin turbo 540 KB Olds with Brodix SR 20 heads. We currently dial...
I cleaned my mag injector very well then rattle canned it with black paint with ceramic (header paint). It held up really well. Just my...
Remember there are DOT regulations for carrying fuel. JW
I agree on the RPM although I haven't used anything else to compare it to. Money spent was very well worth it. JW
Not a drag racer--tractor puller. We ran 496's with 14's at 45 over, one a standard rotor SSI and one a Littlefield HH. Your numbers don't look...
Track workers actually had all four motors in the back of separate pickup trucks and the bare chassis off the track in about 20 minutes. It was...
At that length, go with a triple axle. The ride is much more forgiving on the vehicle, tools, and everything inside. JW
On both our Pioneer front drives, I used the billet aluminum one on both the mag base and oil pump drive on BBC. I think it was a Moroso unit or...
I tractor pull. Our pulls last from 12 to 15 seconds. I have used Red Line for about 6 years or so. I have never had an issue, except for one...
