Separate names with a comma.
Concerning the back to the pump thing. It's kind of hit and miss and depends on the combo. I run into it occasionally and it flat vibrates the...
SAE used to make a shield/deflector that went around the hat nozzles. Basically they were cute round cups with a slot to slip over the lines and...
Kestrel 4250 for me. The Density program for best jet guessing.
Your driver would have not liked the 60s-70s. "Puke tank, we don't need no stinking puke tank. Too heavy!":cool: Dave Koehler...
Switch the struts? Dave Koehler http://www.koehlerinjection.com
For that size engine with an 80a-1 pump start at .006 on the BFs and 36% on the BV. It will start and run. Then adjust to suit. When done leak...
Mike C. No blower on the OPs engine. Dave Koehler http://www.koehlerinjection.com
Wonder how long they ran the SB without oil. Dave Koehler http://www.koehlerinjection.com
ehhh..no......EGTs are not an A/F tuning tool. ET is #1 with the spark plugs #2 as confirmation. Look up Mike Canter's paper on alky plug reading....
Lenco used to make them. Maybe they still do. There is also the possibility of stepping up to the Enderle 600. That's what I use on SBC blown...
Sounds like the rear (internal) seal has dried out somewhere along the way and is now leaking out the rear. This will take out the shaft bearings...
That's kind of rare. What does Melted mean? What cooked?
Interesting John, What about this? I use the torch, set it fat to lay down a layer of black carbon. Then I reset normally and heat until the...
Do you rotate the engine 90 degrees every now and then while priming? All those oil galleys need to line up to send oil on to the next point.
Brandon, The hats are Cast. Unless the industry has improved this service it will result in a flat blotchy finish. Dave Koehler...
To the OP. Unless you have a reason the fuel path on the enderle is through the square edge side, not the screwdriver side. That taper was added...
Splain' it to me please. How does tooth spacing make HP? Dave Koehler http://www.koehlerinjection.com
http://www.pppcenter.com/ These might be the only people that will discuss it. They have centerless grinders and ground down some odd ball pins...
I always thought this shield was less clutter for the automatics but I wonder if it's dimensions are such that it could slip in the can and solve...
Was not knocking your chosen race series or efforts. The word "clear" set the whole thing off and for my part was attempting to throw a little...
