Separate names with a comma.
rb0804, the crank trigger box doesn't get enough signal at normal starter cranking speeds to start the motor. Some people use a 16 volt battery...
GTPerf, yes I believe you are right the click I'm referring to is that faster rotor movement when the magnets pull the pointer to the next...
I'm trying to better understand the MSD 44 Mag. Here are few questions I have: 1. Is the correct timing position of the rotor right before it...
I believe you should fill it initially to ~6 psi empty; when your oil pump fills it up it will read around 60 psi or what ever your pump can put...
Mike et al, jet boats are in gear at the starting rope with the motor off and the jet exit closed. Once we pair up, the starter asked us if we...
Thanks guys for the great advice. This site has been very valuable for me. Thanks, Joe
I replaced my wet oil pump with a 5-stage dry sump pump. Due to the vacuum caused by the dry sump air is now being pulled into the engine through...
Scouder, I think you solved our problem thanks. I now believe my BV is set too rich also and that's why it takes a couple of seconds to clean up....
I also have a RPM Data logger in my PE boat with a 14-71 and my egts go up steadily all the way to the line. Don't worry about it as long as the...
Follow Up The guys that told me detonation was the problem was right. Too much timing at 34-37 deg. for the amount of fuel. In another thread...
Mike, the valves are Manley stainless and I haven't pull the heads yet. I'm using the Comp. Cam triple drag race springs with an installed force...
I did a leak down test on my 565 BBC with Pro-1 heads after ~35 passes. I"m running a 14-71 Littlefield on alky at 20 psi boast using a 44 mag...
I am running NGK-R5671A-9 plugs. I check the plugs this morning and they all looked good to me. No black specks on the porcelain that would...
Now I am confused, why would a 44 mag set at 34* look like 40* to the motor? Only the top gear drive socket head bolts are backing out not any of...
That's for all the input guys. I'm going to go with Relentless and stud it. I don't think its detonation because I'm only running 10.5:1 comp....
It seems that after a pass or two, screws are loosing up on my gear drive cover even after using lock-tight; is this common? I was thinking of...
Launch Retard The Digital-7 has a Launch Retard function capable of retarding the motor up to 25*, up to a maximum time of 2.5 sec. At the...
Thanks guys for all the input. I can see that both methods are used, pulling out timing and riding the dots. Now my question is which is the...
I'm currently running a 44 mag with a 8145 box on a 565/14-71 BBC blown Alky motor in a boat. To soften the launch I'm using a Digital-7...
Jay, Thanks for the tips. I have heard that Brad Penn oil is the best. I have used my pan heaters to try to remove the alky but its not like...
