Separate names with a comma.
Troy, Check your PM's.
Don't know if would be more efficient (like building boost as quickly at lower rpm) but it would run cooler, just something to think about since...
Is a 9.5" that much stronger than a 9" and what would have to be done to use the bigger gear in a Strange Toploader?
will the stock main caps be up to the task,even with a studs and guirdle kit to stiffen it? -should i lower the static compression to 11.5?(been...
Hey Mike, Tried to answer your PM, your inbox is full, Cell number is 615-403-2256 Thanks, Ronny
Hey Avenger, I'd definitely be interested in hearing more about any possible 4.10 deal. Not real sure I'm going to have many places to run...
Mike, At what RPM would a Mag III retard 4 degrees? I'm running a relatively (to most of these guys) low rpm combo, usually 7500-7800. Would the...
A lot of good logic going either direction, but keep in mind what your engine, tranny combo is when you're looking for a used chassis. There are...
I'm not sure of the amperage draw but I have both solenoids wired to my transbrake button, with no problem. If you're running through a delay box...
My car originally had the 2.25's, never had a problem with steering but was a little concerned with the slight bulge in the tire even at 45 pounds...
NHRA can promote the alky cars till the moon turns green....people in the stands are going to watch what they want to watch........ :(
What this deal actually is, is just a thru-bolt spacer with a register for a torque convertor snout, its a deal that Coan (and maybe others) makes...
I suppose its entirely possible, although as I mentioned earlier, I have a real mental block about the propertys of electrical components. I got...
Just thought of something else....the inner gear of the pump, the tangs are supposed to be to the rear, if the gear got turned around so that the...
They're not, thats what's confusing me about this.......Fly, is there any evidence the convertor ballooned or the snout too long and pushing the...
I had to dedicate a ground to the air dump solenoid, the one with the teflon plunger after I got shocked one time adjusting it laying on the...
Beat me to it 85, guess I type too slow...... :D
What did the shim/backside/pump plate (whatever its called) look like? Any metal transfer (doubtful since it's steel) or discoloration? Not sure...
