Separate names with a comma.
Great job Mike and Joad! That's a huge accomplishment! Josh Long
KBhemi w/ Brad fuel heads. After a race I drain the oil and wipe down the underside from pulling the valve covers after each round. However the...
But is that okay? Is a -16 enough flow?
Looking to buy an oil pan for kb wet sump. Is it okay to have a -16 pickup in the pan and adapt to our -20 line going to the pump?
I wondered....we'll get some lines on it. thanks Mike. I need a checklist of everything that needs bought every year or so...lol Josh
Not sure, atleast 4 yrs old. Only ran the car 2 of those 4 yrs.
Mike, we wondered if it was a port line so we swapped it with the one on the other side. However we didn't get to run due to a oil leak after the...
KB526, 1471 35%, BAE fuel heads, bruno/lenco 2 sp, promag 44, 1/8th mile. Over the weekend we had #3 cylinder start getting hot 3.3 seconds into...
We've used the SAE 50w by schaeffer for the last 2 yrs on our 526 blown alky hemi. No problems, brgs look good. Oil pressure seems to be on the...
I use the simpson-20. They are kinda thick, but you get use to them. Had to take the elastic out of the forarm band so they would slide over my...
PAC 1249 or 1349? Blown hemi, fuel heads. Would i be okay w/ the 12's??? Josh
Spud @ www.fuelinjectionenterprises.com/ Great guy... Josh
so you couldn't use that wire for ground on a nitrous fuel solenoid?
The 8973 manual says that wire will provide 5 amps continuous ground when enabled. If you have your shift light set at say 6000, your light will...
Anyone ever used the Orange/Yellow shift light output wire for ground on a hi-speed solenoid? ie, to where the solenoid is on after a certain...
Pretty sad. Track and crew were top notch in my opinion. Josh long
You need to figure what % of that 16gpm was going in the motor before. To do this find: Total Nozzle Area (area of all your hat jets and port...
Anyone ever had problems w/ their Bruno band sliding off of the dowels? After a run, the band is sliding torwards the back of the car to where...
I have a MSD 7531 we used on our promag 44. 1 1/2 years old...works great. $625 Give me a call if interested... Josh @ 316-650-0624
Another alternative is to put an electric high speed (solenoid) on it and then you don't have to worry about changing spring pressures w/ main...
