Separate names with a comma.
Yeah just to clarify, my sensor was in the port block behind the ck valve. pump sensor was in the pump.
what if the port ck is subtracting from the total? eg. 100 before bv, 95 after bv, 75 in dist block due to 20lb port ck
I forgot about the fuel filter. That'd definitely make for more pressure on the pump side. I figured the barrel valve isn't a solid run...
Hey thanks for the info! That's more than I thought it would be, however that is at a higher rpm and higher pressure. Thanks again
Anyone recall roughly what the fuel pressure drop is through the barrel valve? eg. fuel pressure at pump is 100psi, what is fuel pressure at the...
It would be interesting to see a non bias party do this test. Not saying ARP is misleading, but I've never seen a test done by a supplier that...
Looking to buy m4 or m5 hi helix blower. Let me know if you have something. Call or text 316-650-0624 Or Email injected68@gmail.com
Thanks micah, after thinking about it there's no solid answer. Totally dependent on how much the barrel valve is open then compared to your total...
Curious what the fuel pressure looks like in the burnout. Say 6500 rpm with the blades barely open. Would port/hat pressure be the same as wide...
17-20 gpm single inlet
Where would someone find a bdk valve for a fuel system? Does someone make them for alcohol? As I understand this is a air controlled fuel...
Depends on your groove on your shaft. We had .060" grooves and had them ground to .100". Lenco said the .100" is the later design.
Mike, sent you a couple emails w/ our grid info. Did you get them?
Is there a standard everyone goes by when checking plug wires? We run MSD wires on our promag 44 hemi, and the longest one is 5', and it measures...
Email sent Mike, thanks
Mike, I have downloaded the grid info but wasn't real sure what to look at. I'll check on these last runs to see if I see anything. Haven't ran...
Anyone ever seen the grid cause engine rpm to be very rough on data logger? Almost like detonation. 520ci brad VI w/ promag 44, roots 35 over,...
Pushrods, measured overall length 5/16" Cup: 10x - 10.675", 3/8-7/16 tapered 16x - 11.040", 3/8-7/16 tapered 5x - 11.450", 7/16-1/2...
I'd second that. Dean is super friendly and the awning quality is top notch! Josh Long
Not sure if one of Casey's question was fully answered. If you have a dual gauge setup and 1st gauge reads 100 psi and second gauge reads 75 psi,...
