Separate names with a comma.
Did they tell you what it's supposed to measure at 1.100" below the oil ring? If they didn't, then the spec they gave you is worthless.
First off, there should be a spec sheet that came with the pistons. This will tell you where to measure the pistons and what the clearance should...
Taper wall pins go egg shape on the ends and make it difficult to remove from the piston. Lighter isn't always necessarily better.
Years back, Darrien had a similar problem at Sonoma. It blew up in the staging lanes when they went to start the car and I think the Toppings had...
I couldn't agree more. Remember, the pin is the only link keeping the rod and piston together. Don't be afraid of a heavy straight wall pin.
;)That means it's time to through it away and get another one, the car that is.
No, I was assuming at the pump. That's where you should be checking fuel pressure. Whenever a fuel system is flowed, it's always checked at the...
Is this a doorslammer or dragster?
Wow, that's a lot of nozzle area. 1. Nozzle area is too big. You need to squeeze down the ports to raise your fuel pressure. If you haven't had...
I would say the bearings are blackened from the oil being so diluted. I find it hard to believe you have 60lbs of boost with all that fuel. As...
What's one of the first things you notice with new hoops? Lots of tire smoke. When tire smoke is gone, so are the hoops.
I've never run into a situation of a 45 degree cam in a 48 degree block. But I would think if your checking the cam to make sure it's the right...
I'll try it. tony_ramos2@verizon.net
I worked there from 1998 to 2006. Iain Graham set him up as a JE distributor.
Dave's a good guy. I used to deal with him when I was at JE. Next time you see him, tell him Tony from JE said hi.
Wow, after all that carnage, how do you know you didn't have enough V to P?
You must run a Newberry motor. Ross made them for C&A when they were still open.
Unless it's been milled out, the underside will tell you who's piston it is, whether it's JE, Arias, Ross, CP or whoever.
Ora says alcohol makes it's most power at 60 degrees.
I remember seeing something awhile back. Someone was asking what John Weaver has been up to. Read on....
