Separate names with a comma.
Thanks guys. I might just change over the pressure sensors on the distribution blocks just to see if they stay the same for curiosity. Currently...
Can you please explain the .36 x boost rule for working out nozzle area?
Hi guys, just wondering how much difference you would expect on fuel pressure at the hat and at the ports? My customer has a sensor on the hat...
How was the cooling system doing anything if it couldn't flow through the engine since the head water ways were blocked. Seems as if you only had...
Just wondering why it has been recommended that when running a cooling system with a blown injected alcohol deal to have a non pressurized cooling...
With piston .015"down, .070" head gasket, 96cc chamber, a 30cc dome gives you 13:1
Thanks for your help Ray, much appreciated. In regards to your swirl pot, does it just have one line in and one out at the bottom to feed the pump...
Mike , do you suggest this way for all engines, even blown SBC with cast iron blocks/alloy heads?
Thanks Ray, can you tell me if your block has separate 'O" rings on each bore or are they joined in the middle like a figure 8. ? They recommend...
Just curious on what total timing a SBC with 23° heads would want on the safe side. Engine is 4.125 bore with 3.50" stroke and has a Littlefield...
Just like to say thanks to Jeff as I did it the way he said and the new 481 X motor fired up straight away & the timing was within a couple of...
Have you guys tried drilling larger drains in the valley to help aid drain back or perhaps extra lines from the heads to the pan?
You mean a 7-4 & 2-3 swap. Known as "C" fire. You must make sure that you have the correct headers first or it will cost you power.
Sorry guys, been busy. Dale , it has no crank trigger. Jeff , I presume you only turn the engine by hand & if the rotor 'kicks" around 50 then it...
How do you guys time a MSD 44 mag for initial start up? I've never played with these. No issues with the point type mag as I can see when it will...
Just putting together a 481X & noticed that the manifold is sealed around the ports only with "O" rings. Do you get any oil leaking between the...
I have several sets in use at the moment but have not done enough work to be able to comment about yet. I did use a set of there earlier sets in...
Joe, are you measuring the weights yourself because I don't even think that you could buy a steel rod weighing that much & if that is the weight...
Wannabe, thanks for the info. As I understand they come in different valve angles but one of the numbers is a program that is suppose to tell...
I can't see it being a good thing as it was designed for Iron blocks as it is suppose to expand at a similar rate to cast iron & not Aluminum
