Separate names with a comma.
Does anybody use King rod bearings in a hemi? how do they compare to clevite bearings for hardness and life expectancy? This is for a roots blown...
Would there be any problems with the driver leaving his foot off the clutch and using the motor to help pull the car up? We have changed from a...
Hi guys, would anyone be able to share there shut down procedure for a funny car with a clutch, in particular when do you push the clutch pedal in?
I am assembling a new BAE short and I want to check the crush on the main bearings can anyone tell me the measurements for what the main tunnel is...
Ok we have pulled the engine apart and had a few people who know more than I do look at it and we found that the rod was cracked through the bolt...
We record 10 seconds of data and there is no drop off in oil pressure and we always have a few quarts of oil left in the oil tank when we get back...
Wow thanks for the info on the M bearings sounds like you saved us a lot more heartache, I'm planning to get the torque wrench calibrated/...
We normally use 'V' bearings, when we bought the 2nd hand rotating assembly it has 'M's in it already so we left them in and ran them. I'm...
The first 2 bearing shell looked like they had been staved of oil, the journals 1st time round was black about 90 degrees around what would be the...
I've put a lot of shorts together for a nitro funny car and we have always run different compression heights on all cylinders, this car is just an...
I assembled 1 and 6 when I first put this latest short together to check piston to head and piston to valve clearances and we had over .100 for...
I made new plug wire before the last race we change them every year and the coil wire twice a year, I'll ad that to my list of things to have a...
We put the first spun bearing down to the ignition timing advancing when the mag drive had come loose although that should make it retard if...
The rods have broken about 2/3 of the way up 1 - 1 1/2 inches below the little end most of the beam has been intact and the big end is in a few...
Ok I'm going to try to get the ball rolling a bit here I guess the biggest question I have is does this sound like parts failure from using...
Kicked a rod again Theres a bit of a back story here so bare with me, I'm crewing on a roots blown hemi funny car we had a really good year last...
Might be a silly question but have you got a windage tray in the oil pan?
What about rod/stroke ratio, if you use a shorter stroke with a longer rod to keep the same compression the piston will dwell longer at the top...
Where are you based Jack?
Crower pedal clutch 3 disk.
