Separate names with a comma.
I used this Mark Williams tool on my Ford 9" and it worked great.
I've been using Loctite 598 Black with good results so far.
Corey, years ago, when I was in the aerospace industry, we used to use Osborne Products for thread plug gauges, you might want to check out their...
Corey, you can try places like MSC, Carr-Lane and other suppliers but be warned, some of those gauges can cost as much as a whole set of rod...
You can get plug gauges for all classes, internal and external. Class 2B has more manufacturing tolerance than 3B does. Most bolts used in...
Ditto on the Gibbs, I've been using it on bare chrome-moly for over a year and it has done the job quite well. Also, you can find it on Ebay...
Greg, I think you need to check the rocker arm assembly using the T & D shaft height gage to verify your stand height is acceptable. Here's a...
Check out this previous topic.
Using thinner head gaskets will increase the static compression ratio.
My 3-2A/20 Deist states on the label "Machine wash warm and gentle cycle. Do not bleach .Tumble dry low heat or drip dry".
How are you setting your idle and at what rpm, and, are all the blades at .006 and where are you checking them? Another thought is, have you...
Possible vacuum leak around the hat area? What is the gap at the blades? Also, what did you set the leakdown at idle?
Mike, any truth about pointing the nozzles in the hat upward instead of down into the blower to further cool and vaporize the fuel?
Mike, not doubting you or Justin, but the disks must be awfully soft to be tested on that scale. Curious, what should the readings be on a disk...
Normally, the "S" scale with that big of ball is for thin soft metals like bearings and such, and harden steels use the Rockwell "C" scale, most...
The quickest and cheapest would be to use heli-coils or threaded-inserts. I still think a reversed-shouldered insert would be the best.
I don't care what grade aluminum you use, a freshly and properly drill and tapped aluminum chunk of metal will still have their threads stripped...
I also agree with Paul (thjts). The round o-ring will expand into the groove sides as the top and bottom of the o-ring is compressed which,...
Gotta agree with Nathan, the aluminum rod threads are much weaker than the steel bolts, the GRP statement sounded more like a sales pitch than a...
Where the outer bearings ride, just behind the axle nut, the Anglia is approximately .625 diameter, the Strange is .750 diameter.
