Separate names with a comma.
would you run the wide tip in the small cap?
I have an MSD 44 mag and several of the standard caps and rotors. I also have several wider MSD rotor tips that I can put onto these caps. The 44...
I retard for the first 1.5 seconds in the Launch Retard graph on the Grid, this post is about overall timing with RPM and whether timing needs to...
Interesting.... Thanks Ken, very interesting..... Never thought of letting the motor run free-er with less acceleration going on down track....
I was thinking one day in the jet..... "Would there be an advantage to adding timing as RPM increases?" Sometimes I have a little too much...
Both "in" and "out" are good, new coil is on car, will probably get a new box (and send the other one in to get tested and fixed if need as I am...
MSD power grid, MSD 44 points box with rev limiter to interact with grid, and a ridiculous 2100 amp Odyssey 12volt (have to weigh 2800 now, so...
Hi again, Went out for the outlaw race tonight, made two attempts at going down the track to further work on my tune and had issues. 526...
6 foot 2, 205, 34 inch waist an bench 250. I'd have to start cutting off body parts ;-) "That cost me an arm and a leg ;-)"
I think some thinner lexan side window and a couple of carbon fiber parts too.
Thanks for the replies. I may get a few bolts for less critical areas, and then "front to back" the car looking at screws, washers and every...
Looking into all sorts of weight loss ideas, any pros or cons to using titanium bolts to replace the 1/2 lower front control arm bolts and 3/8...
I am pretty new to the 44 mag setup as well. JR suggested, and I bought the part you have listed above, it has worked flawlessly. You can also...
I have a 24 and a 25, is there a 23?? TIA
Doesn't sound like a 70 pickup truck any more Went over the motor from top to bottom, everything was extremely happy. Was able to fit pulleys...
Thanks!! Called Tom, very helpful, thanks!!
I have no idea, but it works. I talked with them in person at PRI in Indy last December and they said "Do this", I did it.... Nothing trick in my...
I mix I am no expert here, but I mix Brad 70 and Valvoline racing 60. I was burning pushrod tips until I added the Valvoline at the...
Hi again everyone, Now that we are making it down the track in one piece, I am starting to look at optimizing rear gearing for 1/8 and 1/4...
MGP Rods, (just bought a set)require straight 50 wt., They were very specific about that.
