Separate names with a comma.
OK, lets back up to go. I had a 10-71 mooneyham gas blower. I stepped up to a 10-71 blower shop alcohol hh piece. Mostly open bottom (my...
MSD 7al for me. Remember, we are not burning a lot of fuel. I have a 600 enderle pump. 10gpm roughly. I ran an 80a-1 for years. It was just a...
Basically we launch from idle. The engine is idling for x seconds. When it is time to leave the holding rope, we go to full throttle. The clutch...
I worked on hat nozzles this weekend. I have them closing up temp wise. I want to get them faily close, then keep going with port nozzles. We...
Hmm. OK, this gives me something to work with. 1) I am fat at an idle. In boat world, it helps to slow down idle so clutch engagement is not an...
Wow! Must be a record. Over 300 views and the only response was from a buddy I have on speed dial. Amazing. Wags
Port nozzles open at 15psi. I think idle is 6ish or something like that. Wags
OK, long story short. I have my RPM data logger all set up and running. I had my port nozzles/ egt temps real darn close. Now, over the winter I...
What dyno? Does it have fuel flow readouts? Air hat on it? Are you even getting the run started? It sounds like not. Quick test for lean/...
Right.. small chisel edge, or punch sharpened. It is a pain in the ass. You will mark up the deck a little. Is what it is. Don't get to worked...
A 7 will be just fine IF your mixture is reasonable. IF your mixture is way out of wack (like you have a big ass pump with little boost) God...
Aircraft spruce has some cool stuff too. There are southco and camloc fasteners that use a phillips screwdriver. There are tons of cool fasteners...
I don't know about dzus... but check out aircraft suppliers. Like... wicks aircraft?? They have tons of fasteners. 1/4 turn stuff... some cool...
I use pro blend or red line. It helps greatly to prevent corrosion. IMO its a bargain at 10 to 15 bucks for a can that does 55 gallons. Wags
No, but I'm not a real blow alky guy. Just an 8.0 drag boat. I have never fouled a plug. Now, it will color them, but as a bracket piece we...
I disconnect my inlet line from the barrel valve. I have a secction of hose made up with an air fitting on it. I put pressure on the barrel valve...
I got the Nitro Helmet Speakers installed. They were a little overpriced IMO, ut they work excellent. They are sort of like ear muffs, they have...
Not everyone uses a ball hone by any means. Not to be a prick, just sayin. But, not everyone has a ck10 in their garage either. With hell fire...
Hack the studs. Why machine the pedistal if the stud is long? You are just taking strength out. 1 thread out is fine. You will be ordering...
I am thinking of bolting on an 8-71 or 10-71 high helix retro piece. I had a 10-71 std opening top and bottom. I only run about 12# boost to run 1...
