Separate names with a comma.
When we ran a Lencodrive - I had a Hobbs switch in the transbrake circuit....creating an open circuit when the trans was in high gear (when air...
To pack the chutes, we turn off the air at the bottle - then bleed the air using the air toggle switch located on the back of the car near the...
Make sure to put a one way valve in the air line close to the parachute launchers....just in case there is an air line failure somewhere in the...
J & S East Valley Garage in Santa Barbara, CA....Jay Roach has passed but i think they still do block repair...very nice work!
New 125" chassis just finished. Cage inside width at shoulder is 20.75". Late model Hemi chromoly rear motor plate (BBC or others available) is...
I don't wanna tank Will's super tool tray sale....but here is what i did a few years ago... Sent all of our service tools to Pit Pal...and they...
Randy recommends not hard mounting any of the sensors....I have mine mounted in a rubber coated flat steel clamp (think heater hose holder on a...
On the Altered style cars the shrouds must have 2" clearance between the top of the shoulder hoop and bottom of the shroud (see my photos...
I'm not sure if carbon fiber shields are OK for funny car....but I was building my shields for Fuel Altered....rule is steel only....they only...
I was on the phone with NHRA tech the winter of 2015 getting compliant for the 2016 March Meet...carbon fiber was in for a while - then...
Time for me to show off...these are the Mckinney shrouds Several photos of assembly... [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] This took about 30...
I have one new and one used Spud Miller (FIE) 10 amp ccw Mallory mag along with his coil - not sure on price but reasonable as I have switched to...
Ring land measures .187" [IMG] Ring land at button measures .190" [IMG] Button shows wear from rocking in bore - allowing the ring land width to...
Maybe a better way to explain this is that my current buttons allow .003" additional vertical ring clearance (making the ring groove .003" wider...
Pistons and pin clearance are exactly the same - the button "ledge" or land has .001" ring clearance compared to .003" before - the button...
Just wondering what clearance I should have between the the landing on the button and oil ring? This button is just below the oil ring and...
I like this! I have plenty of the DOT black in stock.....and lotsa heat shrink tubing in assorted colors....thanks!!
I would like to color code my air lines....anyone know where to buy Parker 1120 colored hose in less than 250' per roll? The black is available in...
Not in any certain order....but here are a few things that will need to be changed... Compression ratio - 6 - 7:1 range Barrel valve - make sure...
Thanks Bob - I will check my numbers and make sure to have the oil environment compatible Locktite on hand!!
