Separate names with a comma.
timing is between 55 and 60 degrees and we have the standard cap...
Eric - Gimme a call on the air actuated hi-speed leanout....Scott Gaulter 515-314-7015
Nice used Dunn 4.3" offset Magneto drive that fits a 426 style hemi - with upgraded PSI shaft & gear. Comes with support block and bracket that...
Casters clamped on for welding position...extension tubes for handles mocked up
I built my own stand.....photo attached...the handles telescope inside each other for about 6' total length....roll into trailer and lock down...
Kinda cool story - Mike Dunn worked for Allen's dad in TX years ago and they developed the offset drive....Allen just acquired all of the Dunn...
2 Engine stands 5" rubber casters. All four wheels swivel and lock, 2"steel tubing, black power coated, 20" tall, 25 1/2" wide, 34 1/2" long 150...
I know this is a really old thread....anyone have any nice AJ II fuel heads laying around? I'll take one or a pair for spares. Must have tight...
My blower belt experience - started with 13.9MM 20 years years ago....tightened rubber band tight cold and broke the belt on our first run when...
All new 413 cubic inch TFX nostalgia nitro short block built in 2013 as a spare. I have never run this engine, just stored in the shop on an...
Funny car/altered puke tank. A little over 2 gallon capacity. Let us know where you want the the entry tubes and drain plug located to allow...
New 125" chassis just finished. Cage inside width at shoulder is 20.75". Late model Hemi chromoly rear motor plate (BBC or others available) is...
https://www.racingjunk.com/Other/184056820/Funny-Car-Altered-Puke-Tank.html
Chris, Ya might be onto something here....it's a nitro car so we have not run it long when these problems occurred...and would not start this last...
There are many threads here on ITA regarding MSD 44 amp mags.....but my problem might be unique... Bought 2 new 44 amp mags, FIE coils and...
Pretty sure the rules allow a couple of access holes in the motor plate....I had them at 4:00 and 8:00 positions but they were hard to get at with...
Maybe I'm missing something here with the rules....but when I ran a Lencodrive, I bored a 1.00" hole in the motor plate at 6:00 position as an...
