Separate names with a comma.
Ncrc You might know but a drive cover is matched to the pump and cannot be replaced without pump being reworked.
Need a bucket for a BAE hemi with funnycar pan. Damage or non SFI ok. Thanks, Mike Bruns 316-259-3883
grid interesting..We have shielded Lahey wiring on all the trigger stuff with good routing and grounds. We had issues on the mag trigger and...
grid Green wire tach. I have confirmed that promag sprintcars can have a bad tach kill the engine through the output wire. Mike, the grid...
After a season long battle with misfires, shutting off and broken belts we completely rewired the car and replaced the 8973 box with a grid over...
chevy We always ran more boost but way less timing in Chevys.32 max with a conventional head and 30 max with 14/18 degree chiefs. They were...
Moroso We ended up with Moroso on our Chevy and they easily beatdown msd. Is the plug end rock solid? That's the question. I have zero complaints...
Whats the latest for hemi plug wires? We ran MSD and they were indestructible other than ohm values going up. Bought a set of Taylor that use...
pin a big cotter pin stuck in the crank oil hole can roll a hemi thrust out and back in.
8973 Sale pending. I'll let you know if it falls through.
200.00 lower price bump
fuel How many gpm at 8 or 9k in low gear? I was surprised to see the 60ft was soft on the run I watched. Is that your first outing at 128%?
vent Even venting the lifter valley would be better. My stock BAE setup forced all the crankcase pressure through the pushrod cutouts to get...
Thinner oil returns to the pan quicker. It makes a difference on a system pushing quantity to the minimum. Most setups just run a huge quantity of...
vent Big hoses from the valve cover/head to pan will return oil and equalize the pressure. Ideally vent the crankcase low instead of on the valve...
paint We stripped a fiberglass car and had good luck with a lot of shop air blasted under the edge lifted with a razor blade. Sometimes we got...
cam keep the blower cam in it...it will make the transition to a screw easier when you decide you want to go fast...hahahaha
Does anybody know if a 66 tooth bottom pulley will work on a bae hemi? Obviously the fuel pump extension will have to be worked over. I'm trying...
et fast smart guys run current heads... Im sure they could go fast with less than than state of the art too. The dyno has shown a couple...
8973 one left 275.00
