Separate names with a comma.
This thread is proof of why we have the lame trigger setups on our cars. Apply bandaids until the engine will make noise. I could never get an...
We did a lot of trigger testing trying to find a misfire. The standard setup is weak. The mags internal trigger produces 3 times the voltage of...
I looked pretty hard at MBR before I switched to BAE and I think its a good piece, but the weight and lack of available spares and data shut it...
We ran a FIE that seemed like a well thought out piece but deleted while troubleshooting misfires and never looked back.
I think the mbr is almost 100lbs heavier than a bae. If it's not fairly current with billet block it can be a total mess. They obviously make good...
low ratio is old tech. I dont think most rockers are even available in low ratio.
Need .900 gears for little bertha pump. I have a nice set of .850 to trade or i'll buy outright. Thanks Mike Bruns 316-259-3883
I don't have the p/n but we run more electronics than you with the one sized for a 2002 gsxr 1000 motorcycle.
Rbs will buy your dry sump plumbing too.
I traded my used dry sump pump and a couple hundred bucks for a new wet sump pump at rbs.
Williams pan with custom sump and no kickout. 12 qts Redline 60wt.standard restrictors in block. RCD/PandP pump. 125 psi max pressure. I think...
Bae6 To clarify I already have bae 5 heads that need work. If you have nice 5s dirt cheap I'm interested , otherwise I'm trying to update to 6 or...
Looking for alcohol heads 6 or newer. Repairs or damage ok. Thanks Mike 316 259 3883 call or text Micah72L@hotmail.com
Does anybody know what the black plastic antenna looking piece pointing out of the grid box does? It's held in with a threaded nut like a...
I built a 69 inch Joey Martin copy bar and it came in at 22 lbs or so. Very happy at 2550 lbs and .94 60ft. Does carbon really save weight over...
springs I posted a spring scenario last week and did a bunch of research on it. To answer your question my data says .040 min to .060 coil bind...
I thought the same. The elaborate RCD degree wheel profile and spline setup is beyond my machining skills. I think Reehl can make the pulley blank...
The only way its possible to tension it correctly is because the 11mm pulley diameter is so big there is room to work. Also we do it at the shop...
We have the strange ultra case now. Made numerous 4.0-3.90 passes at 2660lbs with a 50.00 used richmond 9 inch progear. Made at least 30 laps...
Redline Always ran it and always have better luck with gears than everybody else.
