Separate names with a comma.
Z Man -- all the upper bearing inserts that sit in the block--not the cap---have one hole in them to begin with--- when you have a properly...
Are YOU drilling the hole in the bearings or are you just using the bearings as they came out of the box ?
Yes , you can run a line from near the oil filter to there ----BAE also sells a hard line to connect the 2 ports in the block if you want to try...
Would you call him and ask him about this engine issue ? Maybe you could help clear this up ? He takes your calls --
If your block has two tapped holes in the back of it ---- there will either be one or two holes in the area between the bellhousing and the...
I think Trick can do this in house ?
You can take a look at the keys in the bore to see if it has sheared the keys --- but you're still going to have to get a strong puller on it and...
At Union Grove this moment ----- minus 8 degrees f RHumidity 64%...
Gibbs is the best !
Why don't you try to circulate the water--- at least to get some pressure to force the water to the hot spots ?
When you call Gates be ready for the phone to go dead when you tell them what you are building ------ they don't want the liability...
200 amps on Argon is borderline on an air cooled machine welding .188 thick Aluminum, and that's assuming it's a small project----- like the...
Maybe Joe can state the whole situation so that it would be easier to help him--- instead of a piece at a time ? I agree a jet boat is a lot...
Joe , what type hull, setup are you running ? To only pickup a small amount of RPM like that isn't normal ---that kind of cu in and blown setup...
Do you guys ever worry about the pump cavitation when you are re assembling a fuel pump ? Maybe it's just me but racing in a pump limited class...
The gear pumps cannot be switched over ------ can you get the motor to run while priming it with a bottle for a extended period ???? Another...
There are forward and reverse rotation pumps-- how is yours mounted ? Are you experienced at starting a blown engine with a primer bottle ?
You need to pull a sleeve out and see what the OD of the sleeve is , then go to- http://www.darton-international.com/sl_tfx.htm and...
Just to add to the post above you may have a 3.400 long pin mixed up with buttons made for a 3.300 long pin for example , have you changed...
I remember a N/FC a few years ago in AZ that hit the wall over a #3 aluminum elbow that was on the oil pump broke .
