Separate names with a comma.
How do you come up with your installed height target number ? What is the lift numbers on the intake and exhaust ? after the rocker ratio ?
I remember a story about Johnny West who started a hemi with no oil pan on just see what was going on ---- it was a absolute wind storm of oil...
bump make offers !
Bump
Bump please
Prices and list updated with changes
Hey Scott , I have not received a check yet ??? What's the story ?
Bump -- will consider any offers !
When all you guys give recommendations on EGT's -- I have noticed that it depends on where the EGT is placed in the header on a set of FC headers...
Contact Closure Driveshaft Sensor -40.00 Inductive RPM pickup with cable-120 Lenco front case bearing -- low drag CS-1 --75.00 new Enderle 16 line...
I changed the idea on cars I have plumbed so the shut off arm is in the down position --- threw all the needless BS away --- I shake my head when...
What happened to him ?
Jody , I am thinking the spray heads have a small orifice size -- what is the total area of the heads in the bar ? How many heads ? To the...
Will , Jim Head had a setup on his cars where the valve covers teed together an ran into a single 3 inch line which looked to tie into a 5 gal...
Amen !
If this is a hemi ? What is your rod side clearance ? Oil pressure at max RPM ?
I vote for a intake leak or a cracked intake port sucking oil out of the valley -- I have seen 2 nd rings upside down in fuel motors -- makes no...
From all I have read here so far it sounds like it's progressed to where the pulleys need to have dogs on the back like the wheels in Top Fuel ---...
If the sleeve isn't making contact with the register in the block at that spot you will get a hot spot as the sleeve can't get rid of the heat...
Good news Joe as I was just reading on Facebook about Dick entering a car at the drag race in Bowling Green , KY next weekend -- Did he just...
