Separate names with a comma.
Mine swings from the trans mounting holes on the side, cause thats the way the drivers foot pivots. Ill try to PM you a photo.
Maybe they want 6"tabs in the cage and 6"tabs under the wing. Or maybe plates bigger than any 'holes' in the cage?
Set up Maybe a wet sump with scavange sections for external head drains and at the backs of each cyl pairs in the valley. Plumbed back to left...
Instead of hi/lo helix. think thread pitch (corse/ fine) and the nuts axial speed per rev.
Idleing make the spacer and brace one piece. Clevice style just enough room to clear the idler the other side have two bolts into the adjustment...
Driveline angle does not effect power transfer unless it doesnt equal pinion angle. Do you mean engine height effecting weight transfer. Are you...
Porsche puts the filter after the scavange section and before the tank. IDK why They also carry a lot of oil in the pan for a dry sump.
Really have to qualify all amswers by the type of mag being used as well as the triggering system.
Made rear end adapters in .5 in increments just for that purpose Right now it balances at 64 inches. Soos I guess thats about 50% If those dont...
The top ring seals by the pressure delta not so much spring pressure. Just like a rubber Oring or seal. Put a gapless in the second grove and...
dont forget with a hi helix the charge goes straghter down than a regular helix. Think of a nut on a bolt; fine vs corse thread.
Yup over center in the cockpit cable in tention.
10.5 ten to eleven is about right but I dont weld the telescope at the front mount til air is in the tires and the motor weight is in. I think...
Still dont understand why first main is only two bolt and all others are bolted all different kinds of ways.
Tried back in the motorcycle days Used 2014 t4 flame sprayed with iron. But the built in stresses caused them to warp pretty bad. Cast tooling...
What do you guys use for four corner oil restriction with the century.
82" out with 1.250x.058 uppers and 1.125 lower No welds on the top bar only sleeves for braces.
specalty? Got some from specalty and the thread form was wrong. Soos if you go that way check em! Better just make your own.
Ok 450 OK 450 on the intake seat. But with all the terror posted about exaust stands pulling whats the lowest you can go on the out valve...
