Separate names with a comma.
I wouldnt make any change unless your on the edge now. I mean why would you up the blower and then handicap it back with fuel?
Notch the tube with a grinder for clearance and then weld a piece into the hole. T & D is good quality stuff but it seems that they have these...
Nitrous tends to last longer in the bottle. Some say to not use it but we have never used anything else and never had a problem.
Stage V Rocker Assembly and BAE Valve Covers would take care of it. Dont sound like a very good idea to grind on your rockers.
Above it says mine are 5 on 5 1/2 but that is incorrect. They are 5 on 5. Let me know if you need them.
So does BAE....the VI is shorter and bigger than the V stuff.
If you dont find a set let me know, I have a new set of wheels and I bought T/F centers for them and have not put them in yet and I was going to...
Unless Chris had an older wheel then he already has the upgraded version. The older circa 95 to 2001(?) were the ones that were upgraded from....
Rods will hit the cam. They can be ground down to clear but this is a real pain in the a#$ and just dont make good sense to me although alot of...
I run a Screw so the teflon wont be a problem but I have ran 10 degree locks and retainers for years and have never lost a valve, I do keep a...
I think he is looking to purchase one locally. I dont remember the part # but it was only like 8 bucks and I didnt have to pay an additional 10...
What brand pushrod does BAE sell/use in their engines?
Pretty much, less maintenence between rounds and change discs less often.
check your messages.
It sure would be nice to see a taylor bag that had seat belt locks that would stay on the chassis and then adjust the bag one time to fit and then...
What is the proper way to set the timing for the first time after installing a crank trigger? What about rotor phasing, how is that done?
Never a problem with ours, other than they are hard to get off if you want to change the color or lettering.
If your talking about the one thats pressed onto the outer hub of the gearset I think that bearing is made exclusively for Lenco. I tried to buy...
Centerline is just for checking to make sure the cam was ground correctly. Install it by the degree BTDC @.050.
I just check them in the firing order intake and exhaust at the same time starting at TDC on #1 and working every ninety degrees from there. You...
