Separate names with a comma.
P&P Stage 2 (RCD) dry sump hemi oil pump, perfect condition, never any damage, oil P/U screen ran on oil pan too, 18 runs, changing to a wet sump...
Found One Today! Thanks, ITA, found a hat today!
Wanted old style low profile hat for PSI style screw blower, send picture and price to csmjimbkyle@bellsouth.net or call 931-580-8804 Shelbyville,...
Found Sleeves I got the sleeves, Thank You, ITA, Jim
Still need 2 sleeves Still need 2 new sleeves if anyone has several left or can use several used if good to run-Thanks, Jim...
Spark Plugs Thanks, ITA, found plenty of spark plugs! Jim
Cost? What is the cost compared to the NGKs. BAE has the R6061 for $4.85 each. Thank You!
Anyone got 30 to 50 R6061-1 spark plugs for sale? I need to finish out the year, before we order again, Thanks, Jim @ 931-580-8804 or...
Too lean? I am waiting on responses too as I just detonated pistons and pinched the second rings and collapsed piston skirts bad! I think we went...
Engine usage? Billy, is the motor being used in a door car, dragster, boat or pulling? That could make some differences? Thanks, Jim...
Ohm good-but still bad! We Ohm our wires every race and they can be 40 to 50 ohms per foot, but still breal down completely and have cold...
Wanted 2 3.75" finish bored KB sleeves, straight 4.7" OD with wide receiver groove if possible. Would like to have 2 new, but would take several...
a980 or r980 Whipple Chargers wanted for rebuilding or parts, please send picture and price to csmjimbkyle@bellsouth.net in Shelbyville, TN or...
Screw blower wheel speed? Again, most of us have close combinations, but have many different wheel speeds at .025, .050 of a second or etc., what...
Mark Williams 11" Gear After reading the information here, can anyone tell me who to contact for a Mark Williams 11" gear? The MW 11" goes to a...
a980 case needed Still need a good or broken a980 case to repair for a project. I will buy an a980 Whipple needing rebuilt or even just worn out...
Message Sent Message sent to your e-mail address-Thank You, Jim
Wanted a980 Whipple Charger case to finish a project, or an a980 Whipple supercharger needing rebuilding or using for parts, please send pictures...
Wanted a980 or r980 Whipple Superchargers for rebuilding or parts, please send price and pictures to csmjimbkyle@bellsouth.net or call...
Mw 11" Trevor, if you are making a lot of power and can change, the Mark Williams 11" is holding up for us on a heavy ProMod. Everyone else we...
