Separate names with a comma.
watch this http://dragrace.academy/off-season-maintenance-part-8-drive-shaft/
tms in Poway, ca . todd is the best . large selection and he supplies most of the pro teams, https://tmstitanium.com/ tell him dan from san...
I have a 45 tooth 14mmgt pulley center flange for sale
Do you still have the Block? If you still have the blocks what condition are they in?
found one, thanks ita for the space! please remove post
WANTED TO BUY HEMI DRY SUMP OIL PUMP . EITHER A P&P OR A SYSTEM 1 THAT WILL FIT A TFX-92 ENGINE. CALL 7605217956 THANKS
best 28 dollars you can spend! works as a throttle stop, just ask mike !
heres some vid I took on Friday tafc, tad, fc and tf at pamona [MEDIA]
talk to Michael hallstead. he has built a few cars using the mw kit. he is on facebook https://www.facebook.com/michael.halstead.52 I have...
WANTED TO BUY LENCO GRAY CS1 CLUTCH DISKS 45 TOOTH 5.250 OD. I NEED THE GRAYS, NOT THE TANS,GREEN, OR BLUES . THANKS EMAIL ME AT...
update . found out my mw alignment bar was bent, so that didnt help, and the car has the crank 8 inches off the ground and can barely get my thumb...
starting on a new alky funny car 125 inch wheelbase .the chassis is built. now wondering what the normal crank to ground heights used are, and...
im still confused if the wiring is correct or not, buuuut I think if you have a distributor that can be hooked to the msd to see if it does the...
make sure the violet wire is the positive crank trigger wire going to the msd, and the negative is the green. they cannot be backwards or timing...
I have heard brad is putting 2 mains in some blocks. it might be a old racers tale, I haven't seen one or pics of one, might be something to call...
will has some real good pdfs that get real specific
this will give you a idea of where to start depending on what cam gear you have and how much each setting is worth...
if you have any 14mm gt pulleys in mag email me at nitrobandit1@yahoo.com please
the car I just picked up had 10degrees of caster, 8.5 degrees of kingpin using strange adjustable height spindles . funny car
update. just acquired a 4.5 bore 10.7 cn billet block. it is 167 1/2 lbs with 8 liners,caps, and side rails. this would probably be the heaviest...
