Separate names with a comma.
Who said the hell with being different and innovation? I just don't think you should be an exception to the rules because you CHOSE to go a...
You missed the part where he said "controlled" lock up. With a clutch you have to tune it and everything around it to lock it up and that's a lot...
As Nitrobandit experienced, usually ring gear failures occur in segments anyway. I've seen ring gears spun off before, never had one fail on us...
As long as the fastening is adequate, I don't see why it wouldn't work. Most of us rely on the burst strength of the ring gear itself as well as...
Mike, smaller OD flywheel and ring gear means it should turn faster with the starter. The problem might be the starter's ability to crank with...
You use 2-steps for the same reason every other door car and other types of clutch cars do.. So the launch/foot swap is consistent and the driver...
2 of those 300's are more than enough to cool the parts when its apart. We usually set one in the chassis pointed at the flywheel and another at...
There goes the purity of the IMIS show that I liked so much...
That 5.17 lap was other worldly good.. And the air was pretty good, but not Maple Grove or Gainesville sub 1,000ft good. That race track was about...
You would be correct. They allow 3-disc with a max diameter of 11" and 4-disc with a max of 8".
NHRA lets SFI 6.2 and 6.3 in Pro Mod. Most likely for the reason you have just stated. I don't believe starter pockets are allowed in 6.2 cans..
Legally? I couldn't tell you, up to sanctioning body I would guess. 6.2 is the spec you'd need to comply... The rating is based on the total...
Jeff, those are some really great ideas. The only thing I'd mention as a thought is that aren't we already supposedly the show cars at a bracket...
As far as the pay cut, the regional purses all went from $16,000 to $18,000. As for a total purse, I'd be willing to bet that tracks paid out more...
I don't know to be honest. I know a lot of the ADRL blower cars used the AFT style cannon that mounts on the side of the can and controls the...
Great job guys!! Monster lap in the final! Refreshing to see someone new in the Winner's Circle!!!
Thank you Rich Putz, Dean Dubbin and Lance Van Hauen for helping the Williams Bros. TAFC this weekend in Earlville. Without your generosity,...
Most run pedal clutches because of the RPM range of the typical blown alky, or at least the screw blown stuff.. You could run a glide, but it...
They didn't move anything on the Topeka make up or Earlville. Just depends on what you're after.. If you need regional races for points, there are...
Ummmm.. Pro Mod and Scooters were all on grass too, and on the the opposite side of the track.. Some Alky cars were half grass/half pavement. Only...
