Separate names with a comma.
Same overdrive?
My thoughts are funny car count already sucks, so they have to do something to save it. Most of the time here in region 1 there is a short field...
https://www.dragzine.com/news/could-a-fuel-nitro-funny-cars-finally-become-reality-in-the-nhra/
You running the msd 600 or something else? Any issues with it?
1.27 is as low as you can go with the hemi small end pin and still get the minimum .300” crown thickness. Things can get a little tricky with...
What about tooth count and pitch? What’s everyone running for a flexplate tooth count? 167, 164, 137? What tooth pinion goes with each?
A bronze floater is just a steel floater with a coating. It does add aggressiveness and it has is applications. Since it’s a coating it can chip...
Not sure what your asking but the whipple displaces more than the PSI, so you would have to spin the psi harder to make the same air. I’m thinking...
Does someone actually offer them? I looked into them awhile ago, they are super expensive. Initially my thinking was that titanium will warp less...
Ever experience a weak or tired one? Would leaving the ignition on for an extended period of time, like until the battery died, affect the unit?
Has anyone ran the 8 plus box? Have you exceeded its capacity? Pros, cons, issues? I’m seeing they compare it to a 20 amp mag.
Anyone have a formula for figuring out what the bearing speed would be? I am curious of the difference. At what point does the smaller bearing...
Any reason why you would want to go with the Chevy journal? We’ve been quick with a stand big Chevy crank in a 481x. BBC mains, rods and rear...
Looking for a set of 481x cast mag covers. Let me know what you got. Thanks. Rob 3 zero 2 463 8018
I’m a go with Uncle Bob on this one. Most modern Hemis don’t make power until 8800. It’s rumored that some don’t see below 9k the whole run.
Just some things to consider, the cdi box requires around 20 amps at full load to operate at peak performance, which means you need to either have...
I usually like to go back to the last thing that I changed. If you changed the way the crank reads, what’s the possibility the timing is off? Did...
looking for 481x valve covers stage 1-3 thanks. Rb0804@aol.com
What do you recommend for higher hp applications?
They had a booth setup last year at PRI, I stopped by and they said they were supposed to test a couple sets in Arizona at the start of the...
