Separate names with a comma.
And I believed I had found why I was blowing the engine:rolleyes::D
I had this deal in the past too. One easy check to see if the crank trigger is working is to use a spark plug wire direct from the coil and take a...
yes, mine is about 90 degrees at idle and will get to about 150 right about a 2 seconds into the run. ALlL is new right now so will need to make a...
I try to keep them as cool as posible and flip them about two times per side to get then as close as posible but 2 thousand in my book is straight...
could somebody elavorate on this anymore? If this is true then I have been doing wrong for 20-25 years..... Not to be a wise guy but to find...
Back then we used to leave at 5500 and run close to 8300-8600 shift What I'm trying to explain is that at that date we only understood that...
I understand what is trying to be explained here but way back in the early nineties before psi screw blower all alcohol cars ran in the 56%...
Hose Clamps Hi dave, with you beeing in florida any marine shop has them in stock, in either stainlees steel or steel. West Marine has a huge...
Other than the rods and cam deal you need to take into consideration that 4.5 is a long strooke for short deck and therefore the piston will be...
Hi guys! I have been following this thread and will try to put my two cents . 1. To keep your engine runing good you can't change the fuel...
teflon end plugs My blower had the end plugs made out of white teflon, after about 25 runs they were literaly eaten by the front end plate of the...
weight I have only used AFT parts in both titanium and aluminum. When compared to each other the aluminum part was lighter in both cases (cluth...
My bad guys! I believed you where talking about a MSD 44 mag. AS I have tried both the MSD two step and the MSD 7531 and both work extremely well.
two step Maybe I don't understand all the trouble everybody is having with the two step , but what I did find out is that it didn't hurt my KB...
whipple I had that same setup a couple of years ago and what we did that time mas to make an adapter that sort of looks like a "z" that moved the...
balancing When you balance a crankshaft in a v8 engine the normal procedure is to use 50% of the combined wreght of both pistons ( actually you...
Anybody here has used or know about this system? looking for information on it.
Outlaw pro mod.hemi 526 No problems here, I have been using it for 3 years. Makes for easy programing thru computer. The only thing I can...
As I understand yoy are allowed a 15" setback from the front of your pulley to the front of your rotor. It gets the blower right at the # 4...
where can I find more info on both the M5 and Mr. Fords blowers, I just haven't found anything .
