Separate names with a comma.
If you are going to run a restraint between the hat and blower, find one with a slightly smaller opening than the blower. Then lay it on the...
A big & ugly and an SSI F3 with an 11.5 opening is a very good combo. The back of the injector opening can be blended back a little for a good match.
At the back of your hat opening you want that angle to remain steady into the blower. If you have a spacer it should continue that same angle into...
If you are not limited on your overdrive and turn your blower 12000 or above you would be better off making your blower opening 11" or 11.5" and...
SOLD
I know most of the top pullers in the country and I don't recall anyone running this blower. 75% of the top pullers are running SSI's and DMPE's...
SSI F3 1471 HH $5500 as is or $5900 freshened at SSI New in 2012 S/N1458 740-501-2114
Are you dead set on a littlefield? I have a nice SSI.
To cut them flat.
Just wondering if a clutch disc could be cut in a brake lathe? Has anyone tried this?
If you bang the blower the Mag case will show it more than an aluminum case. Now the billet case won't make you any more HP provided all...
How big is the vent on your fuel tank? Might be trying to suck the tank in. Try it with the cap off!
compression ratio and fuel capacity I would say also giving the info you have shared about your current blower you will need to be aware of some...
Selling blowers And sometimes people that update every couple of years have good stuff for sale and care that someone can get good parts and...
