Separate names with a comma.
Good Afternoon. I have what was described to me when I first purchased it is a Newbery/Veney combination motor with Venolia pistons. At one point...
Keep it tight, I've settled on the B10 ES plug with a .019" gap. But that is at low boost (only 26 lbl) I'm only a Fast bracket racer so I keep...
They advertise 1800 Max
I use MSD wires with NGK Plugs...No issues
I'd ask LENCO...who would know better?
I've had it as fat as turning Brad Penn into Pea soup but usually just as stated a slight lightening from fresh[MEDIA]
Nope...standard pump, an O ring around the Drive shaft tower and another around the discharge passage
If it aint broke ...dont fix it! For reference, I run a Bruno/Lenco. Plain olé Type F in the Bruno and straight 30 wgt in the Lenco, Only time I...
Yea I already moved away from that block and now have another Stage 3 that needs different attention.... see post about Saddles. Thanks...
I have a KB Stage 3 block that had some main journal repair. Unfortunately they cut the block leaving the caps at full height. This has created...
I'll bite... where are us using and why?
Thanks...the plan is actuality to use it as a cackle motor
Nope... Ruining without one (crank support), first time ever. Its a bracket car not a lot of boost... it has PSI spline
