Separate names with a comma.
It seems that you all agree on shorter stroke for BBC engines so you can get a decent length rod in it. Is there a point where shorter strokes...
I have a Mark IV iron 9.800 BBC.
I was considering dropping to 3.766" to keep the piston speed down and the cylinder wall happy. Might still go that route.
Ya. I'm trying to get by on a relatively small budget which is why I was questioning the girdle. We're not pushing it too hard - 1100 to 1200 hp.
Yes. That would be the type of girdle I am referring to. If I did go to a straight 4-bolt conversion, would I also have to replace the rear main...
Looking for opinions on main girdles. I have a line on a good Mark IV BBC that is a 2-bolt main. I would normally pass, but the guy is desperate...
You know, collectors. Those things right before the mufflers that the street car guys haveta run :D
This will be a small-bore engine of 4.310, moderate boost of 20# and 8,000 RPM.
