Separate names with a comma.
with a PSI screw on a 540 chev P/M we have two timers to lean out the bottom end. I was wondering how much fuel volume should we be looking at?...
if the carbs are not alcohol carbs they will not deliver enough fuel regardlus of jet size. the emulsion tubes will be too small along with the...
I custom build a lot of billet stuff for local FC guys I have some spars in stock and some designs ready to go I also have some airfoil software...
we run a 355 and we have 12" x 32.5 tires on a 225"wb red, we have 1.09 60' leaving @ 1600 rpm, most people tend to go to a tire too large and it...
We run a sbc with a set of RHS iron heads. 500lift cam Diamond pistons 11-5-1 cr, std 671 I modified for race set up, old int man, dart lock 4.00...
even with the suggested nozzles if the fuel sytem reaches 90 psi it is good for 1150 hp 28 nozzles at the same press 960 hp, remember if the...
I would suggest putting in 4 32 nozzles in the front cylinders, 80 pill cw 50hs @ 40lbs if it runs rich bring up the main to 088. and lower hs...
we re aneel the gaskets by heating them up in a barbq to 600 deg then drop them in cool water this will soften them up. then install them and...
Fuel We run a simualr setup,, I would take the nozzles to 42, 43 , 45 , 48 81 pill 52 in HS @ 35 psi, launch @ 1600rpm. our engine has...
We have a Sbc powered dragster and were wondering if someone could give us some advice on running on 30% Nitro. We currently have been running...
We run a dragster at 2800ft Sbc 671 @ 2% over, 74 cast iron heads, 110 pump, 10.5 -1 comp, 411 gear, 27 degrees timing,car is probably 1-200 lbs...
