Separate names with a comma.
I'll give it a shot. Thanks again!
I don't have the shielded cable. Didn't even know they offered one. I'll have to look into that. I'll also double check what I have it routed...
I had the plugs gapped at .025 and it was more frequent, yes I run a crank trigger, no boost (it's injected) and I don't have my computer on the...
I think I put this out here once before but here goes... I stage the car, put it on the trans brake and if I open the throttle real quick the...
We run quite a similar set up in an altered and found anywhere 6 psi or lower shakes the tire. We always run 6.5 to 7 psi and it helped alot. Just...
Fatten up the barrel a little. The reason it does it is it goes lean, the rpm goes up, the pump spins faster, it gets more fuel, the idle goes...
You will need to gap the plugs fairly tight. .019-.021. If you gap them too large you will drop cylinders under a load. Timing as far as I know...
next question... what difference using zoomies compared to colector headers?
ER70S is fine or you could use 60 if you have it. Those are common fillers. The number designates tensile strength 70 is 70,000 lb. For what your...
The bearings look great and the oil looks fine too I was just saying no sense pounding on them any more than necc. Plan on taking it out again...
Just to clarify this is non-blown, the stroke is 4", the heads are Brodix bb xtras 325 on the intake side, and comp is 13.38. We currently run it...
Looking for opinions on ign timing for a 509 bb chevy. Alky hat inj on tunnel ram, MSD 7 box, 1.76 glide 4.30 gear in an altered. Anyone with...
