Separate names with a comma.
looks like a lenco drive, I ran hygard in mine last year and clutches had zero wear and oil looked great doing it again
Crush washers will eventually pinch the top thread in the head and making it hard to thread the plug in or worst cross thread it . I use flat...
enderle mag and pump drive
search ebay for nupro bellow valves
make sure shut off valve is shutting off return, it will run with the return open just no pressure
I'm worry Mike I meant that as a sarcastic benefit of your theory more fuel the better in the top of the blower, I have no fuel in the rings,...
I have no doubt that misting nozzles can have an affect on the air temp if located far enough up stream, but putting 9 gpm instead of 5-6 gpm...
Just my opinion, it's more important for the intake of any pump to have a non-turbulent flow at the best angle to load the rotors, in the case of...
we're charging the back side with a regulated 50 psi so that it doesn't compound that way all 3 qts discharge at a constant pressure and engine...
we use a 3 qt accumulator but we charge it and the filter with oil using a enderle 110 pump and drill motor. Then at start up charge the back...
8000 in the lights ran 33od most of the time would go 6.40s with equal air 38psi always made good boost just takes a lot of hp to do it can't tell...
went 6.33 215 with a 540 bbc bb2 brodix head Gibson miller 1471 @ 39 od 43psi in a 2000 lb t/d put on a f11 fowler @ 29od went 6.07 225
