Separate names with a comma.
What’s the bearings look like? Are they all wide or just 1 or 2? That would dictate if you need to work on a cylinder or two or the entire system.
The rule of thumb is if your not going to heat cycle the engine that month, you should relax the torque on the aluminum rods and re-torque them...
If you have your grid set to log data you can look at the ignition in and Ignition out which is the trigger in and output to the coil. So does it...
If you put the starter on the drivers side you can run a kick out on the passenger side if your into that. I like the addition of the “Bickel...
What does the timing light say when you activate the curve? Does it match the racepak or the grid? Like I said above if you have an independent...
I would say that the grid is executing what is programmed, not what it’s reporting. Depending on the settings in the grid, you can cheat the...
Are you able to drop 175 lbs. out of the car if you add an iron block? I’m thinking it was about 125 lb difference or so between engines going...
I’ll take a stab here. You didn’t mention what box your are running or how the timing is being recorded. If your running the command module the 5*...
You have the cables for the burst panel? It runs across the burst panel and ties to the “dog bones”? If that cable isn’t connected, or it’s...
With carbs?
Anyone run a PSI screw B rotor? What overdrive did you run? I did a search and found some info, but not really overdrive specific info. I am...
Everything is better with rpm, except your valve train. Some funny car guys run a lot of GPM and don’t pull timing. It’s all about what your setup...
Thanks for the heads up it got caught in my spam filter. Happen to have any pics of the piston? What heat range? You could aim the two outers...
I sent you a private message.
