Recent Content by raw

  1. raw
    Thread

    Offset pully or not

    Looking at going with a PSI D Rotor on my Brad 5. I have a standard Brad intake. With a standard 3.70in snout on the PSI, will I be using a...
    Thread by: raw, Dec 14, 2009, 1 replies, in forum: PSI Superchargers Tech Questions
  2. raw
    Thread

    PSI Screw manifold plate design

    On the plate that goes between the screw blower and manifold, I have seen a couple of designs. One wide open with no restrictions, and one that...
    Thread by: raw, Dec 9, 2009, 1 replies, in forum: PSI Superchargers Tech Questions
  3. raw
    Thread

    Main Brg, pop out of caps, BAE?

    :mad:When putting the main caps back in my BAE, I have a very hard time keeping the brgs in place in the caps. Because the caps fit so tight in...
    Thread by: raw, Mar 18, 2009, 14 replies, in forum: PSI Superchargers Tech Questions
  4. raw
    Post

    Lenco Clutch Pack / Disk alternate

    Someone told me that they thought that the clutch plates out of an older jeep/amc automatic to be the same as a CS1??????????:confused:.
    Post by: raw, Jul 30, 2008 in forum: PSI Superchargers Tech Questions