Separate names with a comma.
We have a steel loop line. before he sent it off, we tested the pump with a drill on the motor and it actually pumped. last night we were bench...
for GP, is there a preferred method for checking the end play. should i make a plate that is same depth as pump, bolt on and check depth of rod...
when we put the pump on originally we checked depths and thought we had the pump end play set correctly. I think this might have to be revisited...
it does have the adjustable clamp. We will check that out for movement. another gentleman said if you can turn the pump with your fingers then...
was speaking with a knowledgeable friend about the problem and with as full as we are filling the tank the vent is covered and might not be...
Thank you, I have read that thread and have checked everything that has been mentioned in there. the motor has ran and i think a few things...
front engine dragster, MFI, what or where should fuel level be at pump with full tank? should it be right at entry (without fitting) to the pump,...
https://neilparks.com/electrical.html
ill take the gloves if you still have em. ill send pm if so.
what size are the gloves?
newb question.. Im wiring sensors up for my FED and wondering about putting a map sensor on the block to measure vac/psi. im guessing on blown...
thanks for the replies, i was looking at few sites. Impact seems to have least expensive set, even with shoes. Ill make a few calsl and see...
I wear size 14 shoe. this is my first time purchasing -20 boots. suggestions on size or which would fit best for big foot. i dont know if you...
